Skip to main content
Topic: 4 layer board panelization (Read 937 times) previous topic - next topic

4 layer board panelization

Hi,

Quote
The 4 layer board house isn't so dirty and WILL NOT accept panelized designs.

Just to verify, what does panelization mean in this case? If I do two designs on same board, but DO NOT use V-groove, line of holes or anything similar, is it still panelization? (I can cut it my self) So this is more like 'money' issue than technical one?

Thanks for good service!

Br,
Tommi

Re: 4 layer board panelization

Reply #1
Panelization is done using vgrooves or slots. If you cut the board yourself it isn't panelization for the factory and you should be ok.

Dunno the real reason behind why it isn't supported. I'm guessing it is a money issue so that the 5x5cm board on the average make money, but an exact 5x5cm not as much or none.