Skip to main content ↑ ↓
Topic: Offset layer in gerber viewer in confirmation email (Read 682 times) previous topic - next topic

Offset layer in gerber viewer in confirmation email

Hello, I just received my confirmation email for an order of four different boards.  In the Gerber viewer that's embedded in the order confirmation page, on two of the boards it looks like one of the layers is offset from the rest of the board.  Is this a problem and if so how do I fix it?  The Gerbers for all four boards were generated using the same cam job in eagle.  I've attached a screen shot.

Thanks!

Re: Offset layer in gerber viewer in confirmation email

Reply #1 –
Maybe this has to do with negative coordinates of your board. Did you use the job file from dirty pcbs? You can try to experiment with the "pos. coordinates" checkbox in Eagle.

Re: Offset layer in gerber viewer in confirmation email

Reply #2 –
No, I used a job file from spark fun.  I've had maybe 10 different boards made using this same job file that came out fine, so maybe it's not a problem.  Either way I'll tryout the dirty job, I hadn't thought of that, thanks.