Skip to main content
Topic: Relay Control Board on DP5031 (Read 14616 times) previous topic - next topic

Re: Relay Control Board on DP5031

Reply #15
Yes, the diode and resistor can be swapped without any real issues. Thanks again!

... especially as the design has now been exposed on Hack A Day. Which I suppose I would rather have happened after I have tested it out.

Re: Relay Control Board on DP5031

Reply #16
Prototypes arrived yesterday from Elecrow. It is an intermediate revision of the design that is probably not suitable for the project I have in mind but might be OK for lower voltages. If it looks like they work for that purpose I will distribute them as freebies :)

Re: Relay Control Board on DP5031

Reply #17
Please put a big warning on it :)

Re: Relay Control Board on DP5031

Reply #18
Yes of course. I honestly think they are probably safer than some of the commercial offerings I have seen. But I have a 240V use case and they are not suitable for that.


Re: Relay Control Board on DP5031

Reply #19
The magic smoke covers it well I think :P

Re: Relay Control Board on DP5031

Reply #20
Magic smoke is prereleased on all designs to ensure zero emissions on site.

 

Re: Relay Control Board on DP5031

Reply #21
Looks good Tom.  Merry Christmas  :)