Skip to main content ↑ ↓
Topic: Compiling OpenOCD with Bus Blaster support (Read 1579 times) previous topic - next topic

Compiling OpenOCD with Bus Blaster support

Hi all,

I'm working on compiling a copy of OpenOCD while I wait for my Bus Blaster to arrive. Can anyone verify whether this is a correct setup if I plan to use SWD support to debug and program ARM Cortex devices?

--enable-ft2232_libftdi --enable-ftdi 

I'm planning on using the Bus Blaster in kt-link emulation mode. The Bus Blaster page here seems to have a lot of information about using the BB with OpenOCD, however it seems to assume that you will be using a pre-compiled version of OpenOCD and not rolling your own.

Re: Compiling OpenOCD with Bus Blaster support

Reply #1 –
Hi Martytoof,

I believe that will enable support for the FT2232 chip used in the BUs Blaster, but I don't know if you need anything else to enable the kt-link buffer support. I'm sorry, I have only worked with compiled versions.
Got a question? Please ask in the forum for the fastest answers.

Re: Compiling OpenOCD with Bus Blaster support

Reply #2 –
No worries, thanks for the reply! I'll report back here when my board comes in in case anyone is curious about what works and what doesn't.