Skip to main content
Topic: Problem communicating with v4 (Read 690 times) previous topic - next topic

Problem communicating with v4


I'm a complete Bus Pirate newbie, and I just received my BP v4.

I've tried to communicate with the device both in linux (ubuntu 12.10), and Windows 7 64bit. Neither is working. I just end up with a blank terminal that doesn't respond to any commands.

In Windows, I've successfully installed drivers and uploaded firmware from The device is recognized by Windows as COM10.

Im using tera term, and my port settings are: Baud rate: 115200, Data: 8bit, Parity: none, Stop: 1bit, Flow control: none.


Re: Problem communicating with v4

Reply #1
Upgrading the firmware to BPv4-firmware-v6.2-r1981 solved the problem!
The device is working fine now.

Can't wait to get started using it!