Skip to main content
Topic: Bus Blaster Free PCB build (Read 3059 times) previous topic - next topic

Bus Blaster Free PCB build

Finished Building the Bus blaster PCB.
Check it out. Soldering the FT2232 was the toughest part. I used Drag Soldering method to solder it . It was My first Attempt at soldering such a small pitch component .Here It is :)

[attachment=1]

The Dangerous Prototypes Sticker goes well with My laptop! :D

[attachment=0]

Thanks a Lot :)

Re: Bus Blaster Free PCB build

Reply #1
Thanks for sharing your build! I should have a new bitstream for this hardware shortly, it is going into production.
Got a question? Please ask in the forum for the fastest answers.

Re: Bus Blaster Free PCB build

Reply #2
It looks great, congrats on the soldering job :)
K - Ditty - Arrrrrrrr ( like a pirate )

Re: Bus Blaster Free PCB build

Reply #3
hmms - would you please test out the new Bus Blaster v3 JTAGkey compatible logic buffer:
viewtopic.php?f=37&t=3993

It works ok in my prototype.
Got a question? Please ask in the forum for the fastest answers.

Re: Bus Blaster Free PCB build

Reply #4
hmmms, did you happen to save your partslist? I have a v3 board sitting here on the bench but I've just been too lazy to go through and pick all the parts out.

Re: Bus Blaster Free PCB build

Reply #5
It's pretty much the same as V2.5:
http://dangerousprototypes.com/docs/Bus ... #Partslist

But all passives are now 0603 (not 0805). There are a few extra parts too, I see if we can dig up a diff.
Got a question? Please ask in the forum for the fastest answers.

Re: Bus Blaster Free PCB build

Reply #6
here is the partlist, the part highlighted in yellow are changed from V2.
Here is the change log


Changed values to Resistors R2, R10, and R11 from 1K to 2K.
Added Resistors R7, R8, R12.
Added Zener diode D1.
Added Resistor Arrays RN1,RN2, RN3.
Removed Resistors R3,R4,R5.
best regards FIlip.

Re: Bus Blaster Free PCB build

Reply #7
Sorry, I guess I should have been more clear. I meant like the digikey/mouser part numbers. Last time I peeked at it the cpld was only available from digikey, and the usb or something was only from mouser, I was trying to find maybe everything from digikey but then I got involved in some other project. I'll have to dig it out again I just don't have time until finals are over.

 

Re: Bus Blaster Free PCB build

Reply #8
The CPLD is only digikey. The other stuff should be available anywhere. I'm sorry, we only have mostly mouser links on our partlists:

http://dangerousprototypes.com/docs/Partlist
Got a question? Please ask in the forum for the fastest answers.