Skip to main content
Topic: Help bus pirate 3.6 (Read 316 times) previous topic - next topic

Help bus pirate 3.6

hi everyone, i'm new and i need help, i have a 3.6 pirate bus card, and i need to read programming an atmega88.
the programming is protected, but I have read that if I install the STK500v2 signature software, perhaps I can read and save the entire programming of the cip. can someone help me.
I just have to figure out where to get the signature software and upload it to the pirate bus, hoping that it works and can read the protected cip. Thanks for your help