Hi,
I recived the bus priate V2.go today. I have the FTDI drivers installed with no issues but the terminal windows displays nothing when I try and connect to it I have tried the "?" command and others, I get nothing.
- I have tried hyper terminal and Tara Term.
- The red power led is on and the green mode led is on, the vreg led is not on.
- I followed the tutorial here (http://http://dangerousprototypes.com/2009/07/23/bus-pirate-101/) and below is attachment of the setting I have used
- I have also tried setting the bits per second in the device manager settings to 115200 and the flow control to Xon / Xoff with no luck.
- 3.3V is present on the ICSP connector
What is going on here, let me know if you want me to measure anything on the board
I have also tried this configuration
Got it working, I upgraded the firmware, I guess it comes shipped with no firmware?
I'm sorry it didn't work. I'm glad you got it working. Yes, you need to update the firmware on v2go, preorder 2. It shipped with the latest bootloader but no firmware.
Here's a bit more about it:
http://dangerousprototypes.com/2009/09/ ... -firmware/ (http://dangerousprototypes.com/2009/09/10/bus-pirate-preorder-2-new-bootloader-no-firmware/)