I have just bought a Bus Pirate V4 and would like to install the latest firmware. I managed to compile the firmware from this link
I have built both BusPirate_v4 and bpv4_bootloader projects using MPLABX 5.10 and XC16 V1.35 without any errors.
I have a Microchip ICD3 and an ICD4 programmer available. What is the SIMPLEST way of wiring up an ICD3 and then re flashing the firmware on the BP4. The bootloader folders in the downloaded files are a bit confusing. Is there a bootloader installed on the board by seed. How can I find out which one and how to use it? I would prefer to just load the hex file directly into the board using an ICD3 if possible or just through the usb port. How can I do this?
PS I have read a lot of the post regarding firmware but have ended getting more confused. The i command gives the following information (no bootloader version info-how do I find this out?)
Bus Pirate V4
I own a Bus Pirate v3, not the v4, so I know very little about it.
However for what little I know through USB should be possible to upgrade both firmware and bootloader by using pirate-loader.exe in command line fashion.
The same thing can be done by using an hardware programmer like the PicKit2 or other like that.
Here it is explained how to do it via USB:
While here it is explained how to do it by using an hardware programmer:
This last link could further clarify the matter:
You probably already know the links I wrote to you, but sadly that is the little I know, sorry.
Be seeing you.