"Your post looks too spamy for a new user, please remove off-site URLs."
…
I'm using the 64-bit 1.2.2 drivers from [FTDI WEBSITE]
Cross-posted on the UrJTAG forum on Sourceforge.
Device shows up in system_profiler:
USB:
USB 3.0 Bus:
Host Controller Driver: AppleUSBXHCISPT
PCI Device ID: 0xa12f
PCI Revision ID: 0x0031
PCI Vendor ID: 0x8086
Dual RS232-HS:
Product ID: 0x6010
Vendor ID: 0x0403 (Future Technology Devices International Limited)
Version: 7.00
Speed: Up to 480 Mb/sec
Manufacturer: FTDI
Location ID: 0x14600000 / 56
Current Available (mA): 1000
Current Required (mA): 500
Extra Operating Current (mA): 0
Chip is XC2C64A. All attempts to use 'cable' command fail:
jtag> cable ft2232 vid=0x0403 pid=0x6010
Couldn't connect to suitable USB device.
Error: Cable connection failed!
jtag> cable jtagkey vid=0x0403 pid=0x6010
Couldn't connect to suitable USB device.
Tried specifying interface=0-5, tried leaving vid/pid out etc. During the configuration stage of the UrJTAG install, the low-level driver for ftd2xx seemed to be picked up:
jtag is now configured for
Detected libusb : no
Detected libftdi : no
Detected libftd2xx : yes
Detected inpout32 : no
Build SVF player : yes
Build BSDL subsystem : yes
Bus drivers : au1500 avr32 bcm1250 bf526_ezkit bf527_ezkit bf533_stamp bf533_ezkit bf537_stamp bf537_ezkit bf538f_ezkit bf548_ezkit bf561_ezkit bscoach ejtag ejtag_dma fjmem ixp425 jopcyc h7202 lh7a400 mpc5200 mpc824x ppc405ep ppc440gx_ebc8 prototype pxa2x0 pxa27x s3c4510 sa1110 sh7727 sh7750r sh7751r sharc_21065L slsup3 tx4925 zefant_xs3
Cable drivers : arcom byteblaster dlc5 ea253 ei012 ft2232 igloo keithkoep lattice mpcbdm triton usbblaster wiggler
Lowlevel drivers : ftd2xx
Running OSX 10.11.2 on iMac (Retina 5K, 27-inch, Late 2015). Goal is SWD debugging a Freescale mcu from a Mac without buying an overpriced J-link segger interface.