Sniffer still not showing signs of being dead. My last post is working its way to the bottom with no suggestions.
I am testing with 5V Pic counting.
Can someone describe what should happen with the Arm and Trig Leds when they hit the Capture?
Before and after?
Mine changes once in a while, not each time?
Can someone suggest a test that tests each of them?
I since have tried jumping a 3.3V on board voltage to Ch0 and still see low.
Thanks
Mike
With 3.3 V on Ch0 and no trigger, I hit the re-capture S and it recaptures LOW still.
I never see the Leds change to ARM and then to Trig?
I finally can see a signal on Ch0 if I set up triggering on it and take the jumper to 3.3V off and on several times.
I can see when it finally triggers?
???
Mike
Hey Mike, sounds like the buffer chip might have been damaged. Please contact Seeed for a repair or replacement .