About 10 calendar days, that didn't take too long to arrive in northern CA. I was bracing myself for a few weeks delay. Thanks also Ian for sending the sample PCB, which arrived a few days before; you are very generous! Is the color code that red=prototype and yellow-greenish = final product? I look forward to trying it out.
Below is photo of the proto and the final stuffed board, which just came in from SeeedStudio:
https://picasaweb.google.com/lh/photo/9 ... directlink (https://picasaweb.google.com/lh/photo/9fwilz2_Pl5bfmUjgvY4eA?feat=directlink)
(by the way thanks for putting the LED/button sample code on it already, nice to see immediately that the board works!)
Thanks for letting us know, it's always nice to know when things start to arrive. We'll start running demos and adding new stuff to the wiki now that people can play :) It's also good to know the PCB arrived, sometimes they get eaten in the mail (corner shredded and PCB falls out).
It is programmed with the #3 demo from the tutorial section (LED inverse) as a self-test at the factory.
Right now Yellow is the initial batch, and after that it is red. The first batch is less dangerous than it used to be, so we'll probably drop that soon :)
I notice the picture is without jumpers on the bank voltage select pins - did it arrive that way?
Yes, there were two jumpers in a separate bag, I didn't install them in the photo, to avoid the longer shadows :-)
I always thought the boards were red, but due to a bad lighting/white balance they look yellowish..
THanks for the picture!