Title: Bus Blaster as Attachment to FT2232H Breakout Board
Post by: frank26080115 on February 24, 2011, 06:47:43 am
Post by: frank26080115 on February 24, 2011, 06:47:43 am
See attached image.
Not economical but I'm getting tired of waiting for the real Bus Blaster.
The .sch and .brd files aren't that clean yet but I'll post them if people deem this idea to be not completely stupid.
Not economical but I'm getting tired of waiting for the real Bus Blaster.
The .sch and .brd files aren't that clean yet but I'll post them if people deem this idea to be not completely stupid.
Title: Re: Bus Blaster as Attachment to FT2232H Breakout Board
Post by: ian on February 24, 2011, 08:44:05 am
Post by: ian on February 24, 2011, 08:44:05 am
:)
Nice idea. I would go with a XC2C32A CPLD so you clone BBv2 though :) The routing should be easier.
Bus Blaster v1 will be available very shortly. It is actually ready to go in the shop today, and I am sending the sell page now. It's going to be sold at cost, and there will only be 20 of them. V2 is in production now (officially!) and will also be available in a few weeks.
Nice idea. I would go with a XC2C32A CPLD so you clone BBv2 though :) The routing should be easier.
Bus Blaster v1 will be available very shortly. It is actually ready to go in the shop today, and I am sending the sell page now. It's going to be sold at cost, and there will only be 20 of them. V2 is in production now (officially!) and will also be available in a few weeks.
Title: Re: Bus Blaster as Attachment to FT2232H Breakout Board
Post by: frank26080115 on February 24, 2011, 04:15:12 pm
Post by: frank26080115 on February 24, 2011, 04:15:12 pm
I'm not that familiar with CPLDs myself. A few 7400s I can handle though.
Good to hear the news about the Bus Blaster V1, I'll be eff-fiving Seeed Studio so I don't miss it. The PCB I got them to make is ready to ship, and Ponoko already shipped my laser cut sheets. :-D
Good to hear the news about the Bus Blaster V1, I'll be eff-fiving Seeed Studio so I don't miss it. The PCB I got them to make is ready to ship, and Ponoko already shipped my laser cut sheets. :-D