| Message |
Board |
Subject |
Date |
| Hey Ian.Its pretty clear we are not speaking the same language, which is my fault. I over-estimated my ability to translate... |
USB Infrared Toy |
Re: getting started.... |
June 12, 2010, 06:43:16 pm |
| Until I hear that someone else has actually done it (controlled a device by transmitting captured remote codes from their PC ... |
USB Infrared Toy |
Re: getting started.... |
June 08, 2010, 06:19:40 pm |
| I contacted rsdio privately, but his Mac program only captures and displays the data. As far as I can tell now, no one has u... |
USB Infrared Toy |
Re: getting started.... |
June 07, 2010, 08:40:29 am |
| has anyone succeeded in doing what I am attempting using the USB IR Toy? That is, use a PC (or even a Mac) to transmit a rem... |
USB Infrared Toy |
Re: getting started.... |
June 06, 2010, 10:24:05 pm |
| Hey Ian, what I am trying to do is what I think you thought you were telling me to do. prt is the port (sorry, should have m... |
USB Infrared Toy |
Re: getting started.... |
June 06, 2010, 03:53:29 pm |
| So far no joy.If I understood the last post correctly, the following code SHOULD play back the code to the toyand allow it to... |
USB Infrared Toy |
Re: getting started.... |
June 06, 2010, 10:58:02 am |
| So far no joy. I can capture the input as bytes that look like this on my textbox display: 127 254 63 254 62 0 63 254 31 25... |
USB Infrared Toy |
Re: getting started.... |
June 06, 2010, 10:51:45 am |
| Thanks again for all the help guys. With the hints you gave me, I was able to adjust my program so the codes receivedmatch ... |
USB Infrared Toy |
Re: getting started.... |
June 05, 2010, 12:00:33 pm |
| Comparing the remote codes I receive in my program with the ones displayed by the same remote signal from RealTerm has shown ... |
USB Infrared Toy |
Re: getting started..... |
June 04, 2010, 08:26:37 am |
| That did it! Thanks! |
USB Infrared Toy |
Re: getting started.... |
May 31, 2010, 11:24:41 am |