| Message |
Board |
Subject |
Date |
| Can someone offer a good inexpensive source for the red and black terminals? Digikey or Mouser? Everything seems pretty pricey. |
Breakout boards |
Re: ATX Breakout Sugg... |
August 14, 2012, 04:29:48 am |
| Many smaller graphic LCD's have a single chip controller IC. Most will interface with I2C or SPI. I2C and SPI is better imple... |
Project development, ideas, and suggestions |
Re: Advanced USB LCD ... |
August 23, 2010, 05:07:27 am |
| I have an AVR board that gets programmed in production and test. It has a 2x3 ISP connector with 2mm spacing. We leave the co... |
Project development, ideas, and suggestions |
Re: Designing jigs fo... |
August 18, 2010, 08:11:55 pm |
| With regard to 3.3V LCD operation:Almost every alphanumeric LCD I have ever worked with can be made to work with a supply of ... |
Project development, ideas, and suggestions |
Re: USB LCD BACKPACK |
August 18, 2010, 04:12:05 pm |
| I have worked with LCD's for about the last 10 years or so and employed by several LCD makers. The pinouts are truly all over... |
Project development, ideas, and suggestions |
Re: USB LCD BACKPACK |
August 17, 2010, 05:09:09 pm |
| Logic Sniffer was mentioned in the Links section of an article in Nuts & Volts titled Reading and Writing an EEPROM Using the... |
Open Bench Logic Sniffer |
Logic Sniffer mention... |
May 07, 2010, 04:34:17 am |