| Message |
Board |
Subject |
Date |
| [quote author="ian"]QuoteYou can take the next comment with a grain of salt, since the owner of OSH Park is a friend of mine,... |
General discussion |
Re: Best cheap PCB se... |
April 26, 2014, 05:14:53 am |
| [quote author="CyberPK"]What do you think about? :)[/quote]The drills in the gerbers are fine so the misalignment is due to m... |
General discussion |
Re: Best cheap PCB se... |
April 25, 2014, 06:59:17 pm |
| [quote author="matkey"]Is that a Nordic chip footprint by any chance?[/quote]Yep, an NRF51822. I've been working with the No... |
General discussion |
Re: Best cheap PCB se... |
April 25, 2014, 06:48:49 pm |
| [quote author="CyberPK"]Post some photos![/quote]Well, OK. Sorry about the quality but I don't have a good camera setup for ... |
General discussion |
Re: Best cheap PCB se... |
April 25, 2014, 08:23:46 am |
| I got my Dirty PCB order a couple of days ago. Not bad turn around to the US West coast. I've had a quick look at them and ... |
General discussion |
Re: Best cheap PCB se... |
April 25, 2014, 04:19:09 am |
| Ian, it looks like KiCAD adds G70* automatically to all the gerbers it generates. |
General discussion |
Re: Best cheap PCB se... |
March 28, 2014, 06:15:29 am |
| I did add G70* manually, but maybe it wasn't necessary with your latest changes. The INCH keyword came from gerbers generate... |
General discussion |
Re: Best cheap PCB se... |
March 28, 2014, 06:05:58 am |
| Looks like the problem was that I forgot the * at the end of G70*. That seems to fix the GML file. Now the order went through. |
General discussion |
Re: Best cheap PCB se... |
March 28, 2014, 04:42:29 am |
| [quote author="NsN"]I'm trying to give it a go, but so far I'm always getting "GML file missing units". I'm using an old proj... |
General discussion |
Re: Best cheap PCB se... |
March 28, 2014, 12:56:15 am |
| OK, issue created. BTW, I suspect that these changes would also enable the OLS client to run on other ARM based single board... |
Client software |
Re: Jawi OLS client o... |
January 11, 2014, 05:53:16 pm |
