| Message |
Board |
Subject |
Date |
| Sorry for the delay .. but i had to do my day job I connected my BP up to my old windows laptop i used to use for device prog... |
Bus Pirate Support |
Re: Firmware 4.2 - BP... |
March 11, 2010, 07:58:20 am |
| Ds30 times out ... i guess it cant see it also when I plug the USB in the PWR and VREG lightswhen i jumper PGC and PGD and pl... |
Bus Pirate Support |
Re: Firmware 4.2 - BP... |
March 05, 2010, 04:20:50 pm |
| sorry my bad .. i was getting desperate and attempted to flash the bootloader too :/pirate-loader_mac --dev=/dev/tty.usbseria... |
Bus Pirate Support |
Re: Firmware 4.2 - BP... |
March 05, 2010, 03:41:14 pm |
| HI I flashed my BP to 4.2 and all was working well (some i2c debuging)i figured I would also try out the STK500 personality a... |
Bus Pirate Support |
Firmware 4.2 - BPv3-S... |
March 05, 2010, 03:27:50 pm |
| [quote author="ian"]Here's a list of parts from the manual that would probably be worth putting on a large PCB of footprints.... |
General discussion |
Re: 3EEPROM preorder |
February 14, 2010, 08:21:16 am |
| Hi Ian thanks for you help , they sure are on (see below)I2C>p 1. Pull-ups off 2. Pull-ups on(1) >2Pull-up resistors ONI2C>WP... |
Bus Pirate Support |
Re: i2c newbie help |
February 04, 2010, 04:15:04 pm |
| I2C>vVoltage monitors: 5V: 4.78 | 3.3V: 3.30 | VPULLUP: 4.78 |I2C>pullup pin in wired to the voltage pin .... yet i still se... |
Bus Pirate Support |
Re: i2c newbie help |
February 04, 2010, 03:14:20 pm |
| Hi , I am just the the process of learning to use my BP3i have a number of byvac relay boards (0x32 and 0x31)i hook up a boa... |
Bus Pirate Support |
i2c newbie help |
February 03, 2010, 09:18:37 pm |