| Message |
Board |
Subject |
Date |
| Quote from: minkok on October 28, 2021, 07:03:18 amIn that case, most likely you have a bad controller or bad programming tha... |
Project logs |
Re: Really universal ... |
October 31, 2021, 05:08:17 pm |
| Quote from: minkok on October 28, 2021, 07:03:18 amIn that case, most likely you have a bad controller or bad programming tha... |
Project logs |
Re: Really universal ... |
October 28, 2021, 09:06:17 am |
| Quote from: minkok on October 27, 2021, 02:39:16 pmCan you Please check also that:Connect T245 without a cartridge you should... |
Project logs |
Re: Really universal ... |
October 27, 2021, 08:45:25 pm |
| Quote from: minkok on October 26, 2021, 11:10:52 amDo not forget, you have to check ( resolder ) on the controller another 5 ... |
Project logs |
Re: Really universal ... |
October 26, 2021, 09:23:32 pm |
| Quote from: minkok on October 26, 2021, 07:26:35 amNow go to repair:Check, resolder with iron ( not with hot air ) all pins o... |
Project logs |
Re: Really universal ... |
October 26, 2021, 09:06:24 am |
| Quote from: minkok on October 25, 2021, 08:23:04 amFor the original JBC t245 the connections are ok.Can you take another meas... |
Project logs |
Re: Really universal ... |
October 25, 2021, 09:20:40 pm |
| Quote from: minkok on October 24, 2021, 08:51:20 amHi, First I want to be sure you connect the handle correctly, just confirm... |
Project logs |
Re: Really universal ... |
October 24, 2021, 09:43:47 pm |
| Quote from: minkok on October 23, 2021, 08:16:11 am I don't have 5.2C board, I am still on the old board and CPU, but they ar... |
Project logs |
Re: Really universal ... |
October 23, 2021, 04:45:38 pm |
| Running into a problem with the assembly, have the message "no tool" (board 5.2C)Using the T245 tip. Calibration works fine.T... |
Project logs |
Re: Really universal ... |
October 21, 2021, 09:58:38 pm |