| Message |
Board |
Subject |
Date |
| Quote from: Virrieth on April 23, 2021, 12:14:38 amHow did you glue it there without a distinct glue blobs under the glass? H... |
Project logs |
Re: Really universal ... |
April 23, 2021, 06:56:35 am |
| My Unisolder is almost ready and i would like to show you. Design is inspired and adapted from this post.The area where the a... |
Project logs |
Re: Really universal ... |
April 22, 2021, 09:19:30 pm |
| I have problems with calibration. Calibration with 0.96" display the R value scatters by 2 units and i think this is fine, bu... |
Project logs |
Re: Really universal ... |
April 02, 2021, 07:00:19 pm |
| Quote from: sparkybg on January 29, 2021, 04:07:47 pmBack board of OLED or back board (where the rectifiers, power mosfets an... |
Project logs |
Re: Really universal ... |
January 29, 2021, 05:02:18 pm |
| Quote from: sparkybg on January 29, 2021, 10:26:19 am1. What do you mean by "power board"? Which board this is? If it is tha ... |
Project logs |
Re: Really universal ... |
January 29, 2021, 04:05:00 pm |
| Quote from: Doomedahab on January 29, 2021, 09:29:18 amIf it's the C revision board it is very unlikely that it's a firmware ... |
Project logs |
Re: Really universal ... |
January 29, 2021, 09:54:33 am |
| Quote from: Doomedahab on January 29, 2021, 07:54:02 amAre you using the latest firmware? Older firmware was fussy about the ... |
Project logs |
Re: Really universal ... |
January 29, 2021, 08:07:50 am |
| I have problems with the 2.42" OLED display. When pressing the buttons to set the temperature (iron isn't connected), the pow... |
Project logs |
Re: Really universal ... |
January 29, 2021, 06:53:38 am |