| Message |
Board |
Subject |
Date |
| Quote from: afedorov on May 02, 2020, 02:01:18 am Your voltages seems perfectly fine. Only R55 separate U17:6 with ADC input,... |
Project logs |
Re: Really universal ... |
May 02, 2020, 08:15:22 am |
| Quote from: minkok on May 02, 2020, 06:29:55 amSpiftacu1ar, can you check -0.6V at U18 and U13 , also at your picture is not... |
Project logs |
Re: Really universal ... |
May 02, 2020, 07:40:08 am |
| Quote from: afedorov on May 01, 2020, 06:17:26 pmTry to adjust the current by up/down buttons in the calibration menu and che... |
Project logs |
Re: Really universal ... |
May 01, 2020, 07:33:35 pm |
| Which voltages would I expect to change when I adjust current? I'm guessing the the 3.8mv should scale with the the current? ... |
Project logs |
Re: Really universal ... |
May 01, 2020, 06:43:42 pm |
| Quote from: minkok on May 01, 2020, 08:19:43 amAlso you can compare your voltages with afedorov's voltage table at a page 137... |
Project logs |
Re: Really universal ... |
May 01, 2020, 06:03:23 pm |
| Measuring fluctuation between ~0.327v and ~0.347v (hard to read, because the number is changing pretty fast) across a 1k resi... |
Project logs |
Re: Really universal ... |
April 30, 2020, 07:14:53 pm |
| First off, thank you all for the support!This morning, I have reflowed u10, u11, u12, u13, u15, u16, u17, and u18U15-5 is now... |
Project logs |
Re: Really universal ... |
April 30, 2020, 05:34:18 pm |
| Turns out my ability to count is bad. I was probing the wrong pin before. U10-9 is fluctuating between ~2.71v and ~2.75v, whi... |
Project logs |
Re: Really universal ... |
April 30, 2020, 07:31:11 am |
| I just finished assembling my boards, and am having some issues with the calibration step. I have a 10 ohm resistor between S... |
Project logs |
Re: Really universal ... |
April 30, 2020, 02:14:33 am |