| Message |
Board |
Subject |
Date |
| [quote author="vulkan35"]Fully assembled PCBs, making 3-4 days, accept paypal. [/quote]Would you sell just the front PCB with... |
Project logs |
Re: Really universal ... |
March 30, 2019, 10:18:53 am |
| Well...The 3D printed parts will have to wait, when trying to get the first print on the Ender 3, the exposed 24Vdc connector... |
Project logs |
Re: Really universal ... |
March 30, 2019, 09:19:19 am |
| [quote author="eric1981"][quote author="lukane"][quote author="eric1981"]Thanks sparkybg for this great designI built one and... |
Project logs |
Re: Really universal ... |
March 27, 2019, 09:54:02 am |
| [quote author="eric1981"]Thanks sparkybg for this great designI built one and works really wellHere's my 3d printed case for ... |
Project logs |
Re: Really universal ... |
March 26, 2019, 12:44:38 pm |
| [quote author="salavat"][quote author="lukane"]I got the PicKit 3.5 recognized by MPLab X IPE, but I was unable to flash the ... |
Project logs |
Re: Really universal ... |
March 22, 2019, 11:38:00 am |
| I was thinking of having a couple of cheap kapton stencils made for these boards, but I could only find the gerber for that f... |
Project logs |
Re: Really universal ... |
March 22, 2019, 10:18:41 am |
| [quote author="Morpheus1979"][quote author="DeKu"]Are there any Suggestions as to what to solder First and what last?[/quote]... |
Project logs |
Re: Really universal ... |
March 22, 2019, 10:12:15 am |
| I thought I was actually banned by a mod, and couldn't figure out why...Having myself been a moderator at a rather large foru... |
Project logs |
Re: Really universal ... |
March 22, 2019, 10:05:25 am |
| Thank you for the replies.I am refering to the primary/mains side fuse.The secondary, 5A fuse, is intact.Running a fever now,... |
Project logs |
Re: Really universal ... |
March 13, 2019, 01:19:21 pm |
| What value mains fuse have you guys used?I have about 232VAC, measured, and a 500mA slow blow blew after a few on/off "cycles... |
Project logs |
Mains fuse |
March 13, 2019, 09:37:52 am |