| Message |
Board |
Subject |
Date |
| [quote author="TheAmmoniacal"]I have built and assembled the UniSolder 5.2 for use with JCB C245, everything appears to work ... |
Project logs |
Re: Really universal ... |
May 27, 2019, 12:18:15 pm |
| [quote author="vulkan35"]Sleep sensor connection example:
[attachment=0][/quote]
do you have that stand for sale? |
Project logs |
Re: Really universal ... |
May 03, 2019, 11:12:27 am |
| [quote author="salavat"]The OLED display 2.42" mentioned in this thread earlier can be connected to Unisolder board as shown:... |
Project logs |
Re: OLED 2.42 connect... |
April 25, 2019, 09:18:49 am |
| [quote author="caled6987"]Hello, Just purchased pre populated PCB's from Vulkan35. So i will be starting this adventure when ... |
Project logs |
Re: Really universal ... |
April 25, 2019, 09:00:38 am |
| hm yes, didn't read it well,so i assume if we convert 240 to 24V so modifier is 10, then if we expect on secondary side 5 A, ... |
Project logs |
Re: Really universal ... |
March 13, 2019, 01:30:47 pm |
| i'm using 5-6 amp fuse, 144W / 24V = 6A, why you thought that 0.5 will be enough. If without iron, maybe you have short somew... |
Project logs |
Re: Really universal ... |
March 13, 2019, 10:57:32 am |
| [quote author="Doomedahab"][quote author="roor"]they should be just above the calibration menu, if they are not there, either... |
Project logs |
Re: Really universal ... |
March 07, 2019, 01:30:42 pm |
| they should be just above the calibration menu, if they are not there, either it is not working or old version |
Project logs |
Re: Really universal ... |
March 06, 2019, 10:29:50 am |
| what do you have expected from new firmware?if you see few new options in menu then you have new one, if not then it is still... |
Project logs |
Re: Really universal ... |
March 06, 2019, 08:41:18 am |
| [quote author="Tony"]RoorMenu long time, plus patches + and -I changed lines 206 and 207. Now it's OKTony[/quote]Hi Tony,for ... |
Project logs |
Re: Really universal ... |
February 13, 2019, 08:00:16 am |