| Message |
Board |
Subject |
Date |
| [quote author="lovethesmellofrosin"]Hello everyone...I've been watching this forum for a while, as I geared up to start my bu... |
Project logs |
Re: Really universal ... |
July 28, 2019, 04:52:50 pm |
| [quote author="zbx89"]Hey guys. I'm about to order some boards through JLCPCB, any thoughts of their quality regarding this p... |
Project logs |
Re: Really universal ... |
June 03, 2019, 05:20:24 pm |
| [quote author="WSlomo"]Finally my UniSolder in casing. This is really very good project. Thank you Sparkybg for sharing it.[/... |
Project logs |
Re: Really universal ... |
May 06, 2019, 11:54:54 am |
| [quote author="afedorov"][quote author="minkok"]Check P2/ pin2 to GND.[/quote]You're completely right, it should be the reaso... |
Project logs |
Re: Really universal ... |
January 06, 2019, 10:43:13 am |
| Thanks for all your answers, will check all that in a week as I'm currently on holiday without access to any measurement equi... |
Project logs |
Re: Really universal ... |
December 30, 2018, 05:46:30 pm |
| Very interesting, just ordered a display :)
Can you share the pinout you used to connect it to the main board? |
Project logs |
Re: Really universal ... |
December 28, 2018, 10:45:13 pm |
| Just got the delivery for the missing parts and replaced Q14 and 16 with Vishay SI2315BDS-T1-E3 as suggested in this thread. ... |
Project logs |
Re: Really universal ... |
December 28, 2018, 11:19:51 am |
| [quote author="afedorov"]Are Q14 and Q16 OK? I see that Q18, Q19, Q21, Q22 is not installed on your board and are of the same... |
Project logs |
Re: Really universal ... |
December 27, 2018, 11:06:27 pm |
| Flickering is exactly as seen in the video, unfortunately.I got this display: https://www.aliexpress.com/item/1pcs-0- ... 4c4... |
Project logs |
Re: Really universal ... |
December 27, 2018, 06:51:18 pm |
| Hi everyone,I've almost finished building my UniSolder controller. Unfortunately, the OLED is behaving strange. As long as it... |
Project logs |
Re: Really universal ... |
December 27, 2018, 01:34:10 pm |