| Message |
Board |
Subject |
Date |
| Hi minkok,I got hold on better equipment and I was able to measure all the voltages of page 139 as well as the one you mentio... |
Project logs |
Re: Really universal ... |
December 08, 2018, 05:42:05 pm |
| Thanks for your input, I'll do that! |
Project logs |
Re: Really universal ... |
December 05, 2018, 08:14:17 am |
| [quote author="minkok"][quote author="max0o"][...] Unfortunately it shows only 1023 as the ADC value in the calibration subme... |
Project logs |
Re: Really universal ... |
December 04, 2018, 08:29:39 am |
| afedorov, minkok,thanks for your hints. I'll try to check that asap and I hope I don't short anything with the tips of the mu... |
Project logs |
Re: Really universal ... |
November 22, 2018, 07:58:22 pm |
| New day, no problem ;)I replaced the broken resistor R53 (I indeed managed to burn off one of its terminals) and I tried to c... |
Project logs |
Re: Really universal ... |
November 20, 2018, 06:28:45 pm |
| Turns out it works just fine if you mount R27 and R28 correctly and not rotated by 90 degrees.. at least it now shows "no ins... |
Project logs |
Re: Really universal ... |
November 18, 2018, 09:36:41 am |
| Okay, if I have to analyze the bus, I'll check that next week, since I may have access to an oscilloscope then.Thanks for all... |
Project logs |
Re: Really universal ... |
November 17, 2018, 09:00:50 pm |
| [quote author="afedorov"]max0o, since you're using SH1106 module, first of all you'll have to apply the patch from page 111. ... |
Project logs |
Re: Really universal ... |
November 17, 2018, 08:34:16 pm |
| [quote author="afedorov"]max0o, firmware expects display with external VCC supply. If you're using generic module, which uses... |
Project logs |
Re: Really universal ... |
November 16, 2018, 09:17:07 am |
| I'm at the moment building my own Unisolder station and I finished the soldering and connection of the PCBs so far. Also I wa... |
Project logs |
Re: Really universal ... |
November 14, 2018, 03:33:19 pm |