| Message |
Board |
Subject |
Date |
| I have some better connectors on the way, in the mean time I soldered another cheep connector to the cable. This time I paid ... |
Project logs |
Re: Really universal ... |
May 15, 2019, 06:04:43 am |
| Success! After i re-flowed the board, i re-soldered the ID resistors and gave it another quick test. seems to be working fine... |
Project logs |
Re: Really universal ... |
May 14, 2019, 01:59:58 am |
| Thanks to all for the help. I’ve been working long hours at work, so I haven’t been able to sit down and start testing voltag... |
Project logs |
Re: Really universal ... |
May 12, 2019, 11:19:08 pm |
| Thanks for all the help, i am going back and trying to read as much of this thread as i can, trying to gain some insight into... |
Project logs |
Re: Really universal ... |
May 10, 2019, 05:14:42 am |
| Quote Q10, Q11, U2. Voltage on C19 should be around 14V. Check continuity between mosfet sources and GND and between drive... |
Project logs |
Re: Really universal ... |
May 09, 2019, 08:47:40 pm |
| [quote author="afedorov"][quote author="joey120373"]lower mosfets? not sure what mosfets these would be..[/quote]Q10, Q11, U2... |
Project logs |
Re: Really universal ... |
May 09, 2019, 07:09:44 am |
| [quote author="afedorov"][quote author="joey120373"]if i plug the iron in, the iron ID changes to 23 23[/quote]Check lower mo... |
Project logs |
Re: Really universal ... |
May 08, 2019, 06:57:29 am |
| hoping someone can help.finally got around to wiring it all up, OLED works fine, buttons work fine, but when i plug in the JB... |
Project logs |
Re: Really universal ... |
May 07, 2019, 08:38:04 am |
| So after shelving this project for some months, I decided to give it a go again. I wasn’t seeing anything on the OLED. I trie... |
Project logs |
Re: Really universal ... |
November 23, 2018, 11:37:31 pm |
| OK, i found the problem, it was the idiot who put it together. Some moron (me...) installed the OLED board upside down..... D... |
Project logs |
Re: Really universal ... |
May 09, 2018, 06:32:20 am |