| Message |
Board |
Subject |
Date |
| The 12mil refers to the drill size, so it's the size of the actual drilled hole you get. This hole is then plated unless it'... |
DirtyPCBs support |
Re: 13mil vias for 2 ... |
April 09, 2016, 10:47:53 am |
| Yep, thanks for the info guys - very helpful. I just went with a drill size of 13mil and added (I think) 4mil for the pad an... |
DirtyPCBs support |
Re: 13mil vias for 2 ... |
March 24, 2016, 04:54:44 am |
| Ah, the problem is I'm using KiCAD and it won't allow a via size <= drill size. Also, the drill size can't be left out or se... |
DirtyPCBs support |
Re: 13mil vias for 2 ... |
March 18, 2016, 06:55:48 pm |
| The minimum hole for a 2 layer PCB is spec'ed as 12mil. I'm curious if this can be used for a 13mil via?I don't normally use... |
DirtyPCBs support |
13mil vias for 2 laye... |
March 18, 2016, 08:32:59 am |