| Message |
Board |
Subject |
Date |
| Ok I just found there is only one PCB in the KiCad project, so I assume the panelizing was made with an other tool, which pro... |
DirtyPCBs support |
Re: How do I make a s... |
March 01, 2016, 07:35:40 pm |
| Hi !I just checked the files you point me and with ZofzPCB it works fine, I can see the holes. On the other hand, the web vie... |
DirtyPCBs support |
Re: How do I make a s... |
March 01, 2016, 07:17:37 pm |
| Hi ! Thanks for the answer.I made oblong holes and tried different ways to make the hole but in the viewer (http://http://may... |
DirtyPCBs support |
Re: How do I make a s... |
February 28, 2016, 06:49:31 pm |
| Hi !I hope you don't mind if I ask my question here, given that it's very close to the original question...I'm also trying to... |
DirtyPCBs support |
Re: How do I make a s... |
February 27, 2016, 04:35:19 pm |