| Message |
Board |
Subject |
Date |
| [quote author="minkok"]..... Is it normal and is it possible to decrease this time around 2s?[/quote]This is not Sparky, but:... |
Project logs |
Re: Really universal ... |
July 06, 2017, 10:20:20 pm |
| and at the basis of Q5 there are the 3V zeners that were wrong..... |
Project logs |
Re: Really universal ... |
July 03, 2017, 01:14:14 am |
| [quote author="afedorov"]..... there nothing on the back board that can cause the problem. [/quote]caution..... There ist the... |
Project logs |
Re: Really universal ... |
July 03, 2017, 01:10:14 am |
| and before reaching the above mentioned Diodes D20 / D21 the signal passes the flat-cable between the two boards........ |
Project logs |
Re: Really universal ... |
July 01, 2017, 02:29:47 am |
| seems ok.....As you can see in the schematic, the signal from the sensor of the iron takes the way over D20 / D21 ---> U16 --... |
Project logs |
Re: Really universal ... |
July 01, 2017, 02:15:51 am |
| [quote author="ScotY808"]I did not let it stay on for very long...hopefully it is okay. I measure 1.1 ohm from red to green w... |
Project logs |
Re: Really universal ... |
June 30, 2017, 11:22:39 pm |
| Hi ScotY,on the picture with your "wiring" there is a second green wire - where is it connected?hopefully not to ground of so... |
Project logs |
Re: Really universal ... |
June 30, 2017, 11:16:46 pm |
| Hi ScotY,if your Iron glew red - there is the possibility that this tip went to Nirwana. when you try a new tip make sure tha... |
Project logs |
Re: Really universal ... |
June 30, 2017, 09:49:23 pm |
| Thank you Sparky!and off course you are right with your objection to the earphone jack.but there is a solder-tip from Weller ... |
Project logs |
Re: Really universal ... |
July 12, 2016, 11:44:36 pm |
| Yes - tweezers..... I'm searching too.But I decided to build them in diy - out of two tips from the c210-014.@ sparky: would ... |
Project logs |
Re: Really universal ... |
July 12, 2016, 10:35:53 pm |