| Message |
Board |
Subject |
Date |
| In the case of init problems it's IMO much more likely that BP was left in a wrong state than that the device is not a BusPir... |
OpenOCD JTAG |
Re: Getting started |
March 13, 2010, 10:47:46 pm |
| The "nice idea" can be borrowed from my avrdude approach to the very same problem - under normal circumstances avrdude resets... |
OpenOCD JTAG |
Re: Getting started |
March 13, 2010, 10:46:27 am |
| Yesterday I got my new BPv3 in the post, straight away upgraded to FW 4.2, built OpenOCD from git, wired BP with my STM32 boa... |
OpenOCD JTAG |
Re: Getting started |
March 12, 2010, 09:19:57 pm |
| [quote author="ian"]While you're in the AVRDude code, do you think it would be possible to add HVP/fuse setting to the the Bu... |
Bus Pirate Support |
Re: Program AVRs, EEP... |
January 13, 2010, 01:04:46 am |
| BP replies 1=OK.. 1 as in 0x01? or 0x31 ie ascii '1'?Will there be a command (commands) for configuring SPI clock/phase, spee... |
Bus Pirate Support |
Re: Program AVRs, EEP... |
October 07, 2009, 10:06:56 am |
| Hi Ian,I think you're making it needlessly complex and slow by sending each SPI byte in halves:0001xxxx//low 4 bits of byte +... |
Bus Pirate Support |
Re: Program AVRs, EEP... |
October 07, 2009, 03:04:18 am |