Skip to main content ↑ ↓

Messages

This section allows you to view all Messages made by this member. Note that you can only see Messages made in areas you currently have access to.

Messages - johna

2
Breakout boards / Basic Usage Questions: FT2232 breakout board
Hello,

In my case I was thinking of embeding the FT2232 breakout board into my project once I verified the basics.  This project will be a one off device.  I have two serial devices I want to interface to USB.

I am thinking that with the one USB connector on the breakout board that the two serial interfaces are joined and the USB connector provides them multiplexed.  Not sure if this is done like a usb hub or through some other mechanism.  Any insight would be appreciated.

Also, any reason the USB pins can't also be exposed on a header?  This would aide in my case but I understand that what I want to do might be "abusing" the intended use.

Alternately I can just incorporate FTDI chip(s) directly as I think I don't need all the support circuitry this breakout provides.

Thanks,

John

( ! ) Fatal error: Uncaught exception 'Elk_Exception' with message 'Please try again. If you come back to this error screen, report the error to an administrator.' in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
( ! ) Elk_Exception: Please try again. If you come back to this error screen, report the error to an administrator. in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
Call Stack
#TimeMemoryFunctionLocation
10.01412259304session_write_close ( )...(null):0
20.01442390904ElkArte\sources\subs\SessionHandler\DatabaseHandler->write( )...(null):0
30.01442391680Database_MySQL->query( ).../DatabaseHandler.php:119
40.05702530424Database_MySQL->error( ).../Db-mysql.class.php:273