Skip to main content ↑ ↓

Topics

This section allows you to view all Topics made by this member. Note that you can only see Topics made in areas you currently have access to.

Topics - beeduino

1
Bus Pirate Support / BusPirate v3 - burnt MOSI line
I have burnt my buspirate connecting MOSI (SDA) line to + of a battery pack.
It is a pure ground on pin 18 of the PIC chip now, so I assume this pin is out of work completely. Other things work according to self test.

So my question is how to recover from this?
 - if buy new one - would you recommend to try v4, even if it's not yet officially released?
 - may I order somewhere new pic chip with firmware preloaded?
 - is it possible to rearrange the problem pin to another one, recompile and update firmware and rewire a little bit on the board?

Interesting, some other device (EV2300 from TI) was connected in parallel to buspirate when it happened. And it survived due to ESD protection gl05t diodes on signal lines. Was it discussed to add some protection into a buspirate?

Thanks in advance.

( ! ) Fatal error: Uncaught exception 'Elk_Exception' with message 'Please try again. If you come back to this error screen, report the error to an administrator.' in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
( ! ) Elk_Exception: Please try again. If you come back to this error screen, report the error to an administrator. in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
Call Stack
#TimeMemoryFunctionLocation
10.01272248560session_write_close ( )...(null):0
20.01332380152ElkArte\sources\subs\SessionHandler\DatabaseHandler->write( )...(null):0
30.01332380928Database_MySQL->query( ).../DatabaseHandler.php:119
40.06962519664Database_MySQL->error( ).../Db-mysql.class.php:273