scheme 1 to 1 UniSolder-5.2 with the pinout of the processor under UniSolder-5.2ะก
make your own version of the boards for the 88 x 38 case, we'll see what happens garbage or not. respect the work of others!!!
Finally some response from seller. Unfortunately not through normal PM but still better than nothing. At least some information is provided now. Next step is to find out why unisolder station is so far away off calibration and doesn't accept calibration. Anything specific to that? Maybe than second problem with automatic protection will disappear.
''make your own version of the boards for the 88 x 38 case, we'll see what happens garbage or not. respect the work of others!!!'' I paid for working unisolder, not to create my own versions. Normally support should be given through seller, not somebody else, correct?
As I know, he uses boards compliant with this project, Sch and firmware should be from sparkybg, and the board maybe is from some other else, just read the last 30 pages (around- not sure). This means things are not so bad. I can understand why you are disappointed, I would be also. If that could relax you.
I already made contact with sparkybg, he doesn't recognize board as developed by him and diagram looks different from original as well(many savings for lower cost). There is nothing from vulkan35 confirming that firmware is same and as per sparkybg, probably is not. He will not support Chinese cloning's as there are significantly different from original project and using unisolder 5.2c to this board is false. No support from seller as well, regardless of his presence here. So I bought something unidentified, pretending to be unisolder 5.2c, but in fact is just a trash.
Looks like other topic from vulkan35 for Collective purchase of unisolder is deleted. It's not a surprise for me, he sending defective units and doesn't respond to PM for issues with them. Firstly it's some unrecognized cloning that is limited to only one channel (without announcing that) with no PCB or firmware available and second doesn't work properly. It's power up, showing temperature, recognizing JBC 210 but temperature is far away from real. Adjusting from menu/potentiometer seems to not work as intended. Last option to increase setpoint to make soldering iron work goes to ''hot'' on display and automatically switching off the iron. So product sold by vulkan35 is completely useless and without firmware and diagrams practically unrepairable(made in china). So in the end, my advice is if vulkan35 (grin4encko.vlad@yandex.ru) try to sell you something, just stay away from this fraud.
