Show Posts - Aconite33

This section allows you to view all Show Posts made by this member. Note that you can only see Show Posts made in areas you currently have access to.

Messages - Aconite33

Bus Pirate Support / Re: Bricked Bus Pirate 3.6a

March 24, 2020, 08:31:27 pm

Well I don't have that avilable at the time, however I was able to follow this tutorial:

https://www.pedalpc.com/blog/program-pic-raspberry-pi/

I got all the way down to trying to talk to it over GPIO, but getting an error:

Code: [Select]

p24 lvp id
pic24_read_config_memory: information: device not compatible

So, not sure what's going on, but I got somewhat close

Bus Pirate Support / Re: Bricked Bus Pirate 3.6a

March 22, 2020, 04:33:47 pm

I have a Segger J-Link. I've been searching around trying to find the appropriate pin up, using OpenOCD. I can't seem to find the correct pin up between these two devices.

I'm still pretty new at hardware hacking so I may not be looking for the right thing.

Bus Pirate Support / Re: Bricked Bus Pirate 3.6a

March 21, 2020, 12:33:29 pm

I'm not sure if I can do that now. When I plug in the bus pirate with PGC and PGD jumper, I don't get any LED's except power.

I can't get anything to connect out of a terminal (minicomp/putty). Not sure if I can get it back into a mode where I can flash the bootloader.

Bus Pirate Support / Bricked Bus Pirate 3.6a

March 21, 2020, 03:55:31 am

Well, I've done goofed and bricked my Bus Pirate 3.6a after having it less than 24 hours.

I was trying to upgrade the bootloader to 4.5 and thought I had everything going for me, until I unplugged the bus pirate after flashing the bootloader. (I did terminal in and get a message about upgrading the bootloader, which seemed to go fine.)

After I unplugged the device, I was unable to to terminal back in using minicom. If I put the jumper on PGD/PGC, the only LED i get is a quick USB and constant Power. No Mode LED.

Is there anything I can do to get the bus pirate responding again?

References I used:

( ! ) Fatal error: Uncaught exception 'Elk_Exception' with message 'Please try again. If you come back to this error screen, report the error to an administrator.' in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
( ! ) Elk_Exception: Please try again. If you come back to this error screen, report the error to an administrator. in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
Call Stack
#	Time	Memory	Function	Location
1	0.0139	2302592	session_write_close ( )	...(null):0
2	0.0143	2434168	ElkArte\sources\subs\SessionHandler\DatabaseHandler->write( )	...(null):0
3	0.0143	2434944	Database_MySQL->query( )	.../DatabaseHandler.php:119
4	0.0576	2573664	Database_MySQL->error( )	.../Db-mysql.class.php:273