1
Project logs / Re: Really universal soldering controller
Раз дело не в этом, может есть мысль, от чего могут быть такие всплески?
С ручкой 245 или 210 станция так же себя ведет?
Messages
This section allows you to view all Messages made by this member. Note that you can only see Messages made in areas you currently have access to.
Messages - vulkan35
С ручкой 245 или 210 станция так же себя ведет?
2
Project logs / Re: Really universal soldering controller
в AM120 нету диодов.На видео не видно маркировки, диоды в нано серии пинцетов.
3
Project logs / Re: Really universal soldering controller
Про диоды не слышал. Вы имеете в виду в нутри пинцета?
http://dangerousprototypes.com/forum/index.php?topic=7218.msg74100#msg74100
4
Project logs / Re: Really universal soldering controller
Can any one tell to me, whats wrong in my unisolder.Диоды в пинцете удалили? если нет удаляйте.
5
Project logs / Re: Really universal soldering controller
"Aggiunta opzione strumento fisso" What does it mean???
6
Project logs / Re: Really universal soldering controller
"Why does the controller loose power and restart?"
Front board not connected:
3.3V = 3.292V
Front board connected:
3.3V = 3.186V
Back board D12, R9
?soldering paste is disgusting, take a soldering iron in your hands and solder everything.
7
Project logs / Re: Really universal soldering controller
Can anyone point me in a direction?
Where are the photos of your boards?
8
Project logs / Re: Really universal soldering controller
Could really use some help figuring out the encoder.
1. Remove schmidt trigger
2. Install capacitor 0603 100n between A-C, C-B
3. ENC - A - 2PPD
Encoder EC11 no-name china.... works great.
9
Project logs / Re: Really universal soldering controller
Trying to put a rotary encoder in, just a generic EC11, but not sure how the wire it up.
10
Project logs / Re: Really universal soldering controller
replace also Z3-36V with KDZVTR36B - 1W by specs with the same case SOD123
More reliable Vishay BZG03C36 36V 3W SMA (DO-214AC).
11
Project logs / Re: Really universal soldering controller
What are the advantages? More reliable?
MJD122 more reliable!
12
Project logs / Re: Really universal soldering controller
Maybe i had bought an already broken Q1
need to replace FZT605 > MJD122
13
Project logs / Re: Really universal soldering controller
Can someone swing me in right direction?
do you think you have the usb port installed correctly??
14
Project logs / Re: Really universal soldering controller
All looks ok
we have to take your word for it. where are the photos of the front board and the calibration menu video?
15
Project logs / Re: Really universal soldering controller
Next step is to find out why unisolder station is so far away off calibration and doesn't accept calibration.
The calibration procedure
Connect a resistor with well known resistance (0.1%) of around 10ohm between SENSEA and Vout1-
Go to "CALIBRATION" submenu
Adjust the calibration trimmer until you get value of "R" as close as possible to the resistance of the resistor, multiplied by 100 (1000 for 10ohm resistor).
