1
Messages
This section allows you to view all Messages made by this member. Note that you can only see Messages made in areas you currently have access to.
Messages - Tecnico
2
Bus Pirate Support / Re: Brick Bus Pirate V3.6
Connect 5 pins from pickit 2 to the pirate bus
Finally use these commands:
- ./pk2cmd / PPIC24FJ256GB106 -E
- ./pk2cmd / PPIC24FJ256GB106 -GF / YOURPATH / Bus_Pirate / bpv3-BL44FW510-DUMP.hex
PD: Do I leave one more step?
Thank you.
3
Bus Pirate Support / Re: Brick Bus Pirate V3.6
In the git repository there is a manufacturing resources folder. That has a complete bootloader plus firmware you can program. However, I don't believe any 3.6 had bootloader 2, that was 3 or 3.1. are you sure it's bricked?
Well I deduce that this brick, because when I access the terminal does not give me the bootloader version, even if I make the bridge in pins. Anyway, what are the files (bootloader and firmware) that you indicate to me and that correct version IAN.
If you could help me relive it, I would appreciate it.
Thank you.
4
Bus Pirate Support / Brick Bus Pirate V3.6
I have the BP v.3.6 that I have no communication with, because I have loaded the firmware v6.1 with bootloader v2.
I understand that I will have to charge everything through the PICKIT, right?
Tell me what correct version I have to put firmware and bootloader to my BP.
This is the PICKIT manual. Is he the one who would have to follow?
http://dangerousprototypes.com/docs/Bus_Pirate_v4_and_Pickit2_(bootloader_and_firmware_updates)
Thank you.