1
Show Posts
This section allows you to view all Show Posts made by this member. Note that you can only see Show Posts made in areas you currently have access to.
Messages - Tecnico
2
Bus Pirate Support / Re: Brick Bus Pirate V3.6
Connect 5 pins from pickit 2 to the pirate bus
Finally use these commands:
- ./pk2cmd / PPIC24FJ256GB106 -E
- ./pk2cmd / PPIC24FJ256GB106 -GF / YOURPATH / Bus_Pirate / bpv3-BL44FW510-DUMP.hex
PD: Do I leave one more step?
Thank you.
3
Bus Pirate Support / Re: Brick Bus Pirate V3.6
In the git repository there is a manufacturing resources folder. That has a complete bootloader plus firmware you can program. However, I don't believe any 3.6 had bootloader 2, that was 3 or 3.1. are you sure it's bricked?
Well I deduce that this brick, because when I access the terminal does not give me the bootloader version, even if I make the bridge in pins. Anyway, what are the files (bootloader and firmware) that you indicate to me and that correct version IAN.
If you could help me relive it, I would appreciate it.
Thank you.
4
Bus Pirate Support / Brick Bus Pirate V3.6
I have the BP v.3.6 that I have no communication with, because I have loaded the firmware v6.1 with bootloader v2.
I understand that I will have to charge everything through the PICKIT, right?
Tell me what correct version I have to put firmware and bootloader to my BP.
This is the PICKIT manual. Is he the one who would have to follow?
http://dangerousprototypes.com/docs/Bus_Pirate_v4_and_Pickit2_(bootloader_and_firmware_updates)
Thank you.