When using my BPv4 UART mode, and i set Live Monitor i can read the data, when i put the device on Transparent Bridge or Bridge with flow control, i don't receive anything, what can be the problem? Thanks
Hello to everyone, i was trying to use the bp as an logic analyzer but i always get the same result, first three channels high, and the last two always low. Any idea what can be the problem?
Hi everyone, I need to repair a dc/dc psu, it's a Linearity electronics, LAD10PFKCP. I was wondering if someone maybe have one of those books with psu schematics. Thanks in advance.
Hi everyone, I just found this :https://www.youtube.com/watch?v=In635nKlMfo ,less than 55usd!!!!, goodbye raspberry pi hello tablet.
However I was wondering someone know about diy pcb/projects using allwinner chips?, There look really hobbyist friendly (even if i can't found where to buy one).
Hi, in the next days I may have a retina display from an Iphone 4, someone knows anything about the protocol of comunication, i know is a spi interface working at 1.8v (source:sparkfun)
I want to monitorate my GPL gas tank (10Kg), but I don't know what is the better way to do it. At first I was thinking at monitoring the weight of the tank, but I don't know if it is a good idea keep a weight constantly on a scales. So any suggestion is welcome. Thanks.
Hi, i build my Part Ninja Free PCB too, as I post somewhere in the forum, i'm having some troubles with the 18f4550 (probably i'm going to replace it with a new one), I didn't put the 5V voltage regulator for now, cos probably i'm going to use this one only with the usb port, but who knows. Here it is:
Hi, I was wondering if someone knows a tool where you select your pic and then just click to select the options you would like to use and then make a header file for c18. So you can easily set all the configuration register( analog, timers, ports). There is something like that on Codewarrior for Freescale MCU.
Ok, these is really weird, I don't know who is responsable of this behaviour, could be: C18, mplabx, devil, Pickit2, PIC. I was playing with the ninja part V1, and i wrote a few lines to show something on the display, so i wrote the code, working code. I programmed the Pic more that once, but nothing, to make a debug I decided to make blink one pin at the time just to be sure that the output works (why shouldn't?), so I removed all the references to the LCD and add the code to make blink one pin. Compile, program, and ..... The display shows what i wrote the first time.!!!!!, is working when absolutely shouldn't. So, i have to call an exorcist? or someone have experimented similar issues?.
