Skip to main content ↑ ↓

Show Posts

This section allows you to view all Show Posts made by this member. Note that you can only see Show Posts made in areas you currently have access to.

Messages - ginpb

3
Bus Pirate Support / BP v4 problem in Logic Analyzer mode
Hello to everyone, i was trying to use the bp as an logic analyzer but i always get  the same result, first three channels high, and the last two always low. Any idea what can be the problem?
4
Project logs / Re: Cheap DIY Usb Blaster compatible programmer
I just made this board (2550) but apparently the firmware on the website (v6) isn't working correctly, the usb device is not detected (bad CDC id in linux)do you still have the hex you used on your board?.
Thanks.
5
Bus Pirate Support / Re: Bus Pirate Firmware 6.3 BETA development
just some suggestions for the new firmware

1) contextual help, when i press ? i want to get only the commands i can use, when i start in HiZ  and i press ? i get  a list of commands and most of them cannot be used on that context. Will be better to see only the options that can be used.

2)connection reminders, when i select a mode would be nice to get a reminder of how i have to connect my bp.
  - for example in UART mode i cannot know from the terminal how to connect my wires.
3) Add PWM and frequency counter directly into the mode menu
4)openOCD
6
OpenOCD JTAG / Re: BPv4 support
Hi robots, I wanted to ask you if there is any news on the openocd support for the bpv4?.
Thanks.
12
Flashrom / Re: [CLOSED] Can't understand why it doesn't work anymore!!!
@ph1ph1l0u you could buy/sample other spi flash chip (doesn't matter if is from another manufacturer, sama capacity though) and try to flash that one outside the motherboard, this way you can easily see if the problem is the chip on the mobo or your setup.
the writing process always stop at the same point? have you tried to fill the memory with 0xff?
13
Project logs / Re: Attempt to fit a quadcopter in a 5x5cm PCB
Amazing project!!!, how will you communicate with the quadcopter? IR, BT or ISM? Still committed to the 5x5 form factor? . Have you take in consideration using a smaller micro, like a cortex-m0 BGA? a little harder to solder but will be smaller. If the DCM is done on the Inertial sensor, the pic will only have to manage the communication and the PID?.
Again, great project. Can't wait to see the first test.

( ! ) Fatal error: Uncaught exception 'Elk_Exception' with message 'Please try again. If you come back to this error screen, report the error to an administrator.' in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
( ! ) Elk_Exception: Please try again. If you come back to this error screen, report the error to an administrator. in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
Call Stack
#TimeMemoryFunctionLocation
10.01512417304session_write_close ( )...(null):0
20.01542548880ElkArte\sources\subs\SessionHandler\DatabaseHandler->write( )...(null):0
30.01542549656Database_MySQL->query( ).../DatabaseHandler.php:119
40.06032688376Database_MySQL->error( ).../Db-mysql.class.php:273