Skip to main content ↑ ↓

Topics

This section allows you to view all Topics made by this member. Note that you can only see Topics made in areas you currently have access to.

Topics - abowman

1
OpenOCD JTAG / Buspirate did not respond - error
I have just received my new bus-pirate, and upgraded it to the latest firmware.  All good so far.  I would like to use it with OpenOCD and an STM32 chip.  I decided to see if OpenOCD would recognise it before I hooked it up to my development board.  However, whenever I run openocd and point it to the interface configuration file I get the following error:

Open On-Chip Debugger 0.5.0-dev-00615-g8902789 (2010-11-25-22:11)
Licensed under GNU GPL v2
For bug reports, read
        http://openocd.berlios.de/doc/doxygen/bugs.html
Warn : Adapter driver 'buspirate' did not declare which transports it allows; assuming legacy JTAG-only
Info : only one transport option; autoselect 'jtag'
srst_only separate srst_gates_jtag srst_open_drain
Error: Error sending data
Error: Buspirate did not respond :( restart everything

Should I expect it to be able to connect without a target connected?  Or have I missed some other step?

Thanks in advance

Alan

( ! ) Fatal error: Uncaught exception 'Elk_Exception' with message 'Please try again. If you come back to this error screen, report the error to an administrator.' in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
( ! ) Elk_Exception: Please try again. If you come back to this error screen, report the error to an administrator. in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
Call Stack
#TimeMemoryFunctionLocation
10.01212251376session_write_close ( )...(null):0
20.01252382968ElkArte\sources\subs\SessionHandler\DatabaseHandler->write( )...(null):0
30.01252383744Database_MySQL->query( ).../DatabaseHandler.php:119
40.05502522480Database_MySQL->error( ).../Db-mysql.class.php:273