Skip to main content ↑ ↓

Show Posts

This section allows you to view all Show Posts made by this member. Note that you can only see Show Posts made in areas you currently have access to.

Messages - AK6DN

1
DirtyPCBs support / 4 layer gerber submission error check
I have submitted a 4 layer design for fabrication, and I get ERROR flags when I look at the layer report.

Specifically, I have .gp1 and .gp2 gerbers for the two inner plane layers, and they are flagged as OK.

However, also listed are .g1 and .g2 layers, which I don't supply, flagged as ERROR (since I don't supply them, of course).

.g1 vs .gp1, etc are noted as being mutually exclusive, so why am I getting this error? Is it expected (and a bug in the analyzer?).

It would also be nice that, for multi layer boards, that the inner planes/layers could be rendered as images, as a sanity check.

( ! ) Fatal error: Uncaught exception 'Elk_Exception' with message 'Please try again. If you come back to this error screen, report the error to an administrator.' in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
( ! ) Elk_Exception: Please try again. If you come back to this error screen, report the error to an administrator. in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
Call Stack
#TimeMemoryFunctionLocation
10.01152247824session_write_close ( )...(null):0
20.01182379400ElkArte\sources\subs\SessionHandler\DatabaseHandler->write( )...(null):0
30.01182380176Database_MySQL->query( ).../DatabaseHandler.php:119
40.05672518896Database_MySQL->error( ).../Db-mysql.class.php:273