Skip to main content ↑ ↓

Show Posts

This section allows you to view all Show Posts made by this member. Note that you can only see Show Posts made in areas you currently have access to.

Messages - jluc

2
Bus Blaster JTAG debugger / Board v3c shipped with PID=0x7780
Hi all,
I just received a v3c board, but installing drivers fails. It appears the board was pre-configured with VID=0x403, PID=0x7780, and not the usual PID=0x6010. This is confirmed by lsusb on linux and usb-view on Windows.
FT_Prog fails to scan the device and consequently I cannot reprogram the EEPROM of the FT2232...
Any hint on how to change the PID ? (beside asking WHY my board was shipped like that...).
Thanks.

( ! ) Fatal error: Uncaught exception 'Elk_Exception' with message 'Please try again. If you come back to this error screen, report the error to an administrator.' in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
( ! ) Elk_Exception: Please try again. If you come back to this error screen, report the error to an administrator. in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
Call Stack
#TimeMemoryFunctionLocation
10.01262258752session_write_close ( )...(null):0
20.01292390328ElkArte\sources\subs\SessionHandler\DatabaseHandler->write( )...(null):0
30.01302391104Database_MySQL->query( ).../DatabaseHandler.php:119
40.05712529824Database_MySQL->error( ).../Db-mysql.class.php:273