1
Bus Pirate Development / Re: Bus pirate V4 Self test results
I have the same issue and as read in other topic here I found explaining the issue and differences
with the self-test for V3 and V4 boards.
I suggest for the dummies like me, support of The dangerousprototypes to change in the "self-test" main page http://http://dangerousprototypes.com/docs/Self-test_guide,
so that it shows the difference between the V3 and V4 self-test's connections on the board.
Here is the results with the connected only "Connect (ADC to +3.3V)",
and wrong for V4 connection "Connect (Vpu to +5V) and (ADC to +3.3V)" .
Connection of V4 prototype --> correct
Code: [Select]
HiZ>~
Disconnect any devices
Connect (ADC to +3.3V)
Space to continue
Ctrl
AUX OK
MODE LED OK
PULLUP H OK
PULLUP L OK
VREG OK
EEPROM
SCL OK
SDA OK
WP OK
ACK OK
ADC and supply
Vusb(5.11) OK
5V(5.02) OK
5V0 VPU(4.94) OK
ADC(3.31) OK
3.3V(3.29) OK
3V3 VPU(3.24) OK
Bus high
MOSI OK
CLK OK
MISO OK
CS OK
Bus Hi-Z 0
MOSI OK
CLK OK
MISO OK
CS OK
Bus Hi-Z 1
MOSI OK
CLK OK
MISO OK
CS OK
MODE, VREG, and USB LEDs should be on!
Any key to exit
Found 0 errors.
HiZ>
and the ERROR result with connection made like the V3 prototype: "Connect (Vpu to +5V) and (ADC to +3.3V)
"
Code: [Select]
HiZ>~
Disconnect any devices
Connect (ADC to +3.3V)
Space to continue
Ctrl
AUX OK
MODE LED OK
PULLUP H OK
PULLUP L OK
VREG OK
EEPROM
SCL OK
SDA OK
WP OK
ACK OK
ADC and supply
Vusb(5.12) OK
5V(5.02) OK
5V0 VPU(5.06) OK
ADC(3.31) OK
3.3V(3.29) OK
3V3 VPU(5.06) FAIL
Bus high
MOSI OK
CLK OK
MISO OK
CS OK
Bus Hi-Z 0
MOSI OK
CLK OK
MISO OK
CS OK
Bus Hi-Z 1
MOSI OK
CLK OK
MISO OK
CS OK
MODE, VREG, and USB LEDs should be on!
Any key to exit
Found 1 errors.
HiZ>