This section allows you to view all Topics made by this member. Note that you can only see Topics made in areas you currently have access to.
1
Good evening.
I wonder concepts.
I'm confused.
Is SPI(Serial Peripherial Interface) and Serial Flash Memory is the same term (meaning)?
I am using the router is operating with only Serial Flash Memory(winbond 25q128fvsg).
However, there is no other router serial Flash Memory.
Uses NAND Flash Memory.
What is the Serial Flash Memory with NAND Flash Memory difference?
Thanks
2
Good evening.
I would like to dump the MCU internal memory.
Model: PIC32MX695F512H
Let me know if you ever know the information.
3
I want to write the firmware to the SPI memory.
However, the following error occurs.
Error: Image size (2260464 B) doesn't match the flash chip's size (4194304 B)!
Help me if he found out a solution.
Thanks
4
Hello
I finished the settings enter the "W" command, the following error occurs
-------------Error Messages-----------------
VREG too low, is there a short?
Power supplies OFF
--------------------------------------------
Do you know about how to resolve the error?
5
Hello
I require two 3.3V pin is.
Bus Pirate is 3.3V pin is not the only one.
However, Bus Pirate is only one is 3.3V PIN.
I use a breadboard?
Or are there any other way?
Thanks
6
Hi. People
Is Open Bench Logic Sniffer and Logic Pirate is there any difference?
Thanks
7
Good evening.
I have a question.
I have been using router has failed.
I would like to proceed with the SPI memory dump.
And I have connected to the SPI memory in the router board using the Bus Pirate.
Do I have to connect power to the router board?
Bus Pirate do you only need to connect a power source?
Thanks