Skip to main content ↑ ↓

Messages

This section allows you to view all Messages made by this member. Note that you can only see Messages made in areas you currently have access to.

Messages - CapnRob

1
Bus Pirate Development / Re: Hand solder BP 3.8?
I know this thread is a couple of weeks old, but for what it is worth, I just finished my 3.8 hardware build.  Soldered by hand using a 10x "watchmakers loupe" to see what I was doing.  Use "no clean" or "water soluble" liquid flux to make life easy.  Be sure you get the polarity of the LEDs right - little green lines on the right for the ones I got.  If you bridge some pins, just add some flux, wipe your tip clean and start by just trying to draw the solder down the legs.  Your tip will usually grab some solder off.  If that doesn't work, use some copper wick, clean them pretty good and rework the legs.

It is a bad ass feeling to hand solder tiny stuff and see the board light up when you finally plug it in.

Good Luck with the build. 

CapnRob

( ! ) Fatal error: Uncaught exception 'Elk_Exception' with message 'Please try again. If you come back to this error screen, report the error to an administrator.' in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
( ! ) Elk_Exception: Please try again. If you come back to this error screen, report the error to an administrator. in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
Call Stack
#TimeMemoryFunctionLocation
10.01232248960session_write_close ( )...(null):0
20.01262380560ElkArte\sources\subs\SessionHandler\DatabaseHandler->write( )...(null):0
30.01262381336Database_MySQL->query( ).../DatabaseHandler.php:119
40.05702520080Database_MySQL->error( ).../Db-mysql.class.php:273