Skip to main content ↑ ↓

Messages

This section allows you to view all Messages made by this member. Note that you can only see Messages made in areas you currently have access to.

Messages - Voltman

2
Bus Pirate Development / Altering the voltage on a BP 3
Hello All

This is my first post and I am a newbie to BP and using I2C. I have not received my BP 3 yet but would like to know if you can adjust the voltage below 3volts. The reason is I have a circuit board with a 3volt battery soldered onto it and run into these boards all the time, so would like to I2C them rather than de-soldering the battery.
My question is, can I lower the voltage to below 3 volts on the BP so as to be able to read the Eeprom, as to read the Eeprom the  max voltage is 5.5v. If I set the voltage to 2 volts on the BP and incorporate the board voltage of 3 volts would the BP be able to communicate with the eeprom.

Many thanks.

( ! ) Fatal error: Uncaught exception 'Elk_Exception' with message 'Please try again. If you come back to this error screen, report the error to an administrator.' in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
( ! ) Elk_Exception: Please try again. If you come back to this error screen, report the error to an administrator. in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
Call Stack
#TimeMemoryFunctionLocation
10.01242259216session_write_close ( )...(null):0
20.01272390816ElkArte\sources\subs\SessionHandler\DatabaseHandler->write( )...(null):0
30.01272391592Database_MySQL->query( ).../DatabaseHandler.php:119
40.05822530336Database_MySQL->error( ).../Db-mysql.class.php:273