Skip to main content ↑ ↓

Show Posts

This section allows you to view all Show Posts made by this member. Note that you can only see Show Posts made in areas you currently have access to.

Messages - DaveLan

1
Bus Pirate Development / Low Cost NX5032 SMT Crystal - Bus Pirate v4
I'm looking at 12Mhz crystal for my Bus Pirate and was wondering if the 5032 Crystal 2P (5mm*3.2mm) would work. The width of the NX5032 is smaller by 1mm but I think the solder pad will fit on the PCB.

My doubts are for the load capacitance. The 5032 Crystal I'm about to order are from ebay and no specific brand is mentioned. By looking at different datasheet from 5032 crystal manufacturers, the  load capacitance varies from 10uf to 15uf.

Will this cause a problem? Should I adjust C7 and C8 to a lower value?

( ! ) Fatal error: Uncaught exception 'Elk_Exception' with message 'Please try again. If you come back to this error screen, report the error to an administrator.' in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
( ! ) Elk_Exception: Please try again. If you come back to this error screen, report the error to an administrator. in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
Call Stack
#TimeMemoryFunctionLocation
10.01142247760session_write_close ( )...(null):0
20.01162379336ElkArte\sources\subs\SessionHandler\DatabaseHandler->write( )...(null):0
30.01162380112Database_MySQL->query( ).../DatabaseHandler.php:119
40.05512518832Database_MySQL->error( ).../Db-mysql.class.php:273