1
Bus Blaster JTAG debugger / Getting Bus Blaster V3c Working
Files being used are in BusBlasterv3.zip from viewtopic.php?f=37&t=3993
I have the power jumper in place but no target connected yet.
I struggled trying to use a downloaded version of urJTAG and then I discovered the modified one that's in the above zip file jtag-rev11.exe.
My problem appears to be that the bsdl file is not recognized. Here's what I can do....
Code: [Select]
UrJTAG 0.10 #1869
Copyright (C) 2002, 2003 ETC s.r.o.
Copyright (C) 2007, 2008, 2009 Kolja Waschk and the respective authors
UrJTAG is free software, covered by the GNU General Public License, and you are
welcome to change it and/or distribute copies of it under certain conditions.
There is absolutely no warranty for UrJTAG.
jtag.c:518 main() Warning: UrJTAG may damage your hardware!
Type "quit" to exit, "help" for help.
jtag> cable ft2232 interface=1
Connected to libftd2xx driver.
jtag> detect
IR length: 8
Chain length: 1
Device Id: 00000110111000011100000010010011 (0x06E1C093)
Unable to open file 'c:tempurjtagdata/MANUFACTURERS'
Unknown manufacturer! (00001001001) (c:tempurjtagdata/MANUFACTURERS)
jtag>
I'm running the jtag-rev11.exe file as Admin from c:Tempurjtag and I've tried putting the xc2c32a_vq44.bsd into a sub directory and right now it's in the same directory. I've also tried...
Code: [Select]
jtag> bsdl path c:tempurjtagwith the file in the right directory but I always get the same as the code snippet above.
Any ideas?