16
Tools of the trade / Re: SMT700 New vision based SMT machine from SMALLSMT
Quote
13 mixed linesI can use 12 mm & 16 mm with these lines right?
Is shipping included in the price?
What OS you need to run on the PC?
Messages
This section allows you to view all Messages made by this member. Note that you can only see Messages made in areas you currently have access to.
Messages - phangmoh
Is shipping included in the price?
What OS you need to run on the PC?
17
Tools of the trade / Re: SMT700 New vision based SMT machine from SMALLSMT
Is the SMT500D a modified machine of the TM240A?
I was hoping that it could fall below USD5K initially...
18
Tools of the trade / Re: High speed Pick & Place for $3600
Quote
just wondering why the SMT50 is considerably cheaper on Taobeo.com?Taobao is basically for the local market in China. While Aliexpress is like the Chinese version of EBay.
So, there's some markup involved here on Aliexpress as they know people from outside of China only would buy them.
I buy stuff directly from Taobao but not expensive machine though. It hard as I depend heavily on Google translator a lot!
19
General discussion / Re: Unfortunate experience with DirtyPCB
[attachment=4]
[attachment=3]
[attachment=2]
[attachment=1]
[attachment=0]
But, the boards are still good to go! :)
20
General discussion / Re: Unfortunate experience with DirtyPCB
I just received my first board 2 days ago.
I used the non-protopack package with ENIG finish.
Not as bad bennyboy's board but I can totally agree that the drill hits are way off mark and lots of through hole pads looks like waning crescent of the moon!
Other than that, the soldermask is pretty good with nearly perfect vias hole tenting.
But, it's still usable in my case and after all it's way more cost effective than the fab I used for production copies.
bennyboy,
What is your through hole annular ring size? It sure look thin from the picture.
21
General discussion /
I tried to start that (with the high spec PCB) few years but didn't work back then.