1
Show Posts
This section allows you to view all Show Posts made by this member. Note that you can only see Show Posts made in areas you currently have access to.
Messages - turboscrew
2
Bus Pirate Support / Re: The cables?
Loads of thanks bearing with me. :-)
Now I have to decide which version. 3 or 4 and where to order...
I know the OpenOCD use still have some problems, but then...
Maybe I could even be of some help in the development...
3
Bus Pirate Development / Re: Jtag register widths and chain size
I still wonder about the "if" on line 95
while(jtagReadBit()==0){
i++;
if(i<250)break;//250 device timout/limit...
}
Otherwise it became quite clear.
4
Bus Pirate Development / Re: Jtag register widths and chain size
BP doesn't do anything for you (except the macros). You have to do the calculations yourself. If you want to select a particular device, you have to find it's position in the chain and do the shifting.[/quote]
Ah, that's what I wanted to know. Good, no FW imposed restrictions.
I have to go through the code again with that in mind...
Thanks.
5
Bus Pirate Support / Re: The cables?
Where does the power come from? Is a separate power supply needed, or maybe the USB-connector or...?
Is Vpu-pin supposed to be (normally) connected to target's Vref?
I don't have a Bus Pirate, but I've been planning to get one. I'd like to know what else I need and how to use it. I was thinking about OpenOCD. But if I get a board with 5V, do I burn Bus Pirate? Or with a board with less than 3.3V does Bus Pirate burn the board?
I just want to be sure I can find all that is needed.
If I need a power with 11,27V and 5A (or something equally weird) I guess I must look for alternatives, because I don't know if I'll ever find such power. ;-)
The problem is: I'm a SW guy with some understanding about HW, not the vice versa.
6
Bus Pirate Support / The cables?
Where does the power come from - esp. v4 if it can power small targets?
And what kind of power is required?
Is Vpu-pin supposed to be connected to target's Vref?
Is there a user manual for noobs somewhere?
7
Bus Pirate Development / Jtag register widths and chain size
How about the device in the chain?
I tried to read the jtag.c, but didn't catch it.
How the device in the chain is selected and
how the different register widths of different devices are handled?
Are they?
8
OpenOCD JTAG / Re: BPv4 support
Also interested.
BTW, what is that pull-up supply voltage?
Is it (roughly) the jtag signal voltage?
Is it (usually) taken from the target (reference voltage?) in case of "external"?