I was just wondering, ¿is it planned to add support for RC protocols (Sony, RCA, RC-MM et all) other than RC5/6 on Irman mode? This would be a blast; Irman even returns enough bits to identify which protocol is being used on each decoded message.
I'm just asking because i have about 7 remotes from different sources on my home, and only two of them seem to be identified by the USB IR Toy, which is a shame. Reviewing the code i reckon this would require some rework for sure...
Hello. I've recently built a single-sided, through-hole version of the USB IR Toy v2, using the schematic posted on the wiki for it without the pin breakout area.
Now, i can program this device just fine through ICSP using the .hex files provided in the package, but the thing is VUSB never raises to 3,3v (floats arround 0,6v) with any of them, so the device never ennumerates. I can confirm the device works flawlessly otherwise (the bootloader alone responds correctly to shorting PGC/PGD after a reset, for example).
Right now my VUSB pin is connected to ground via a .47 uF cap, but i've tried several values without making any difference
¿Could it be possible that some configuration bits need to be set up manually? I've checked the design so many times i'm positive that it is correct. Is either that or a dud 18F2550 with a broken internal regulator, but i've never seen such a thing happen in the past. I've used a JDM-type programmer with both WinPic800 and piklab-prog, with identical results.
Thanks in advance!
PS: If anyone is interested in a single-sided PCB for the IR toy just let me know. Mine is 40x50mm using an USB-A connector and includes a USB pin header, VCC/GND/RX/TX header for serial communications and ICSP - had to dispense with the pin breakout area though.
